¶ Solutions：
¶ 1. Fully lubricate the optical axis and slider with grease to ensure that there is no obvious resistance when sliding the slider
¶ 2. Ensure that the belt tension is consistent across all three axes and that the belt is not worn or stretched
¶ Reference Video：
¶ 3. Change the fill mode in the Cura slice software to: Gyroid
¶ 4. Decrease print speed and increase nozzle temperature
¶ 5. Set the extrusion flow rate to 90%-95% in the Cura Slicer software
¶ 6. Modify the motor mode in printer.cfg on the pc side
¶ High speed mode: 999999 changed to 0 (motor changed from silent mode to high speed mode, torque become bigger). Save and restart after all data modification to take effect
