¶ 1. Install the leveling module
Remove the leveling module and place it on the connection at the back of the nozzle.
Then connect the leveling module port to the upper housing "Level Switch".
¶ 2.Click "Configuration" - "Hotbed Leveling" - "Calibrate" - "Continue", please make sure the leveling module is plugged in before leveling. Make sure the leveling module is plugged in before leveling. After the first leveling is completed, the printer will reboot to the main page.When the system reboots back to the main interface, click "Configuration"-"Hotbed Leveling"-"Hotbed Grid"-"Continue". Continue". The printer is leveled for the second time, and the operation is the same as the first step.
¶ 3. When leveling is complete, remove the leveling switch and unplug the leveling module from its socket. Click on "Configure > Bed > Move Z0 > Continue".
¶ 4. Take a piece of A4 paper and place it under the nozzle, click "Z Calibration" - "Z+/Z-" to adjust the nozzle height. Push and pull the A4 paper, when you feel a clear resistance, this is the best distance, no need to click the save button, the system has automatically saved the value.
