¶ Phenomenon:
¶ When clicking "Home", leveling or printing, one axis will not move. As shown in the figure, click "Home" to return the X and Z axes to home normally, but the Y axis will not move.
¶ Reason:
¶ It is usually caused by the limit switch being damaged or the driving block being burned.
¶ Solution:
¶ 1. Click "Tools > Move" to individually control the movement of the axis that will not move. Take the Y-axis as an example, click "Y-". If the Y-axis can move, the limit switch of the Y-axis is damaged. The limit switch needs to be replaced.
¶ 2. If the axis still cannot move, the drive block corresponding to the axis may be burned or the motor wire may be loose.
¶ (1) Check whether the corresponding motor wire is loose
¶ (2) Exchange the corresponding drive block on the motherboard with the drive block of other axes, and then click "Y-" to try. If the Y axis can be fixed, the drive is burned out and the drive needs to be replaced.
¶ 3. If none of the above methods can solve the problem, the motor of the corresponding axis is damaged and needs to be replaced.
