¶ 1.Install the leveling switch, the installation is as shown in the figure:
¶ 2. Click "TOOLS" - "Auto-Level"
¶ 3. Click "Auto Leveling" - "Confirm"
¶ 4. Wait for the automatic leveling to complete, which takes about 3 minutes. After completion, remove the leveling switch and disconnect the leveling switch cable.
¶ 5. Click "MOVE Z0", make sure the leveling switch is removed and click "Confirm"
¶ 6. After the nozzle moves to the position close to the hot bed, take an A4 paper and place it between the nozzle and the hot bed
¶ 7. Click "Adjust Z0", click Z- or Z+ to adjust the Z height
¶ 8. Push and pull the A4 paper while adjusting until there is a slight friction feeling, click "Save" and then go home in parallel with the arm, and the automatic leveling is completed
