The V400 uses four 2226 drives, the XYZ axis drive default through the current 1.5A, the extruder drive default through the current 0.9A. Increasing the current can increase the motor drive torque, but will also lead to increased noise. In addition to excessive current will lead to poor heat dissipation of the drive, the machine can not run properly, it is not recommended to exceed 2A
- TMC stepper motor drive reports an error
- The after-sales service team has determined the drive fault through analysis
H2, H2.5 hexagonal wrench
New 2226 drive
¶ Safety Tips and Precautions
- Make sure the machine is powered off before starting any disassembly and assembly
- Pay attention to anti-static when unplugging the driver, static electricity may cause damage to the driver
- Pay attention to the direction when installing the driver so that the color is consistent
https://www.youtube.com/watch?v=Fx27En0GoEc