¶ I. Effector adapter board
The effector adapter board serves as a connection and adapter, allowing these effectors to be easily connected to the main control board.
¶ II. When to replace
- The port on the adapter board is damaged or has poor contact;
- The adapter board is obviously damaged.
¶ III. Tools used
H1.5 Allen wrench
H2.0 Allen wrench
H2.5 Allen wrench
New effector adapter board
¶ IV. Replacement steps
Note: The disassembly operation needs to be performed when the machine is powered off.
¶ 1. Use the H2.0 Allen wrench in the accessory box to remove the two screws that fix the effector line card and remove the effector line.
¶ 2. Use the H2.5 wrench to remove the two screws that fix the effector fan cover.
¶ 3. Use the H2.0 Allen wrench in the accessory box to remove the 6 screws that fix the hot end and extruder.
¶ 4. Carefully remove the silicone sleeve of the plastic rib tube, remove the nozzle, and take out the effector.
¶ 5. Take out the kit and remove the cooling fan fixed on the effector housing.
¶ 6. Unplug all terminals on the effector adapter board and use an H1.5 hex wrench to remove the screws that fix the adapter board.
¶ 7. Install a new adapter board.
Note:
When installing the effector cable, make sure to insert the effector cable to the bottom.
