¶ I. XYZ axis belt
The S1 belt model is 2GT-9 belt, the single belt length is 1345mm, and there are three belts on the T1 machine.
¶ II. When to replace
Belt stretching deformation
¶ III. Required tools
Tape
New belt
H3.0 hexagonal wrench
¶ IV. Steps to replace the belt
¶ 1. Use the H3.0 hexagonal wrench in the accessory box to remove the four screws that fix the belt adjustment kit;
¶ 2. Remove both ends of the belt from the pulley;
¶ 3. Tape the two ends of the new and old belts together;
¶ 4. Pull the old belt to make the new belt pass through the motor synchronous wheel, remove the old belt, and fix one end of the new belt to the pulley;
¶ 5. Pass the other end of the new belt through the synchronous belt tensioner and install it to the pulley;
