¶ 1. Problem phenomenon
(1). Click feed, no filament is extruded;
(2). The filament is not extruded during the printing process.
¶ 2. Reason:
The nozzle or throat is blocked, and the extruder is blocked.
¶ 3. Solution:
Note:
a.The disassembly operation needs to be performed when the machine is powered off.
b.After clicking "
", wait for the filament to be completely unload before manually pulling it out. To avoid clogging, do not manually pull out the filament before it is completely ejected.
c.When replacing the filament, you can directly cut the filament above the PTFE tube, and then click "Extrude" to allow the filament to be completely extruded to prevent clogging.
¶ (1). First, make sure that the filament is inserted to the bottom, click "", wait for the nozzle temperature to rise to 240℃, and automatically load the filament.
¶ (2). If the filament cannot be extruded, use the silver needle in the accessory box to unclog the nozzle, and click " " again
¶ (3). If there is still no filament extruded from the nozzle, try to exit the filament, click "", and a pop-up window will appear. Please select the appropriate temperature to exit the filament according to the printing filament. It is recommended to select 180℃ for low-temperature filaments and 240℃ for high-temperature filaments;
¶ (4). Pull out the filament;
¶ (5). Disassemble the effector to check whether the throat or extruder is blocked;
