¶ 1. S1 nozzle
Material is hardened steel, V6 short nozzle, default 0.4mm.
Note: Personalized ordinary nozzles can be replaced for printing according to printing needs.
¶ 2.When to replace
¶ (1). Wear and tear
¶ (2). Blockage
¶ (3). Replace nozzles with different diameters according to different printing needs.
¶ 3. Tools and materials needed
Sleeve
New nozzle
¶ 4. Replacement steps
Note: The nozzle temperature is high after heating, and tools are required to assist in disassembly. Pay attention to safety.
¶ (1). Remove the silicone sleeve from the nozzle, and then heat it to exit the filament.
¶ (2). Use the sleeve in the accessory box to remove the nozzle.
¶ (3). Place the new nozzle into the sleeve, tighten it, and use tools to assist in installing the silicone sleeve; or wait for the nozzle to cool and then install the silicone sleeve manually.(When installing a new nozzle, it can be installed in a heated state to avoid improper installation and subsequent leakage.)
Note: When installing a new nozzle, make sure that the nozzle is tightened and not skewed to ensure that there will be no leakage, material clogging, or printing problems during the subsequent printing process.