¶ 1. Effector Adapter Board
The effector adapter board plays the role of connection and adapter in the 3D printer, allowing these effectors to be easily connected to the main control board.
¶ 2. When to replace
¶ (1). The port on the adapter board is damaged or has poor contact;
¶ (2). The adapter board is obviously damaged.
¶ 3. Tools required
H2.0 Allen wrench
new adapter board
¶ 4. Replacement steps
Note: Before replacement, please heat and eject the consumables first, and then disassemble them; the disassembly operation needs to be performed when the machine is powered off.
¶ (1). Use the H2.0 hex wrench in the accessory box to remove the two screws fixing the effector cover and remove the cover;
¶ (2). Unplug all terminals on the effector adapter board;
¶ (3). Replace the new effector adapter board. Be careful to use gentle force when installing the terminals to avoid damaging the adapter board port.
¶ (4). Install the effector shell, pay attention to sorting out the wire sequence before installing the effector shell, and place the wire sequence inside the shell.
