¶ 1. Click "
"-"Filament"
¶ 2. Cut one end of the filament at a 45° angle, push it out from the bottom material tube of the filament box, pass it through the filament detector, and feed it down to the effector until it can't be pushed further;
¶ 3. Install the filament on the filament holder;
¶ 4. Click "Load", set the appropriate temperature for the filament, and wait for it to reach the preset temperature, then the printer will automatically load the filament;
¶ 5. After loading, clean the filament on the nozzle, click "
", and select the model to be printed;
