The S1 machine has a molding size of up to 320x320x430mm. This is an assembled, fully enclosed 3D printer with a maximum printing speed of 1200mm/s and an acceleration of 40000mm/s². At the same time, it has excellent print quality through functions such as automatic leveling, vibration compensation, and flow calibration. The machine is equipped with AI lidar and a high-definition camera, which can issue a warning when printing fails. The heating bed also has a zoned intelligent heating function, which is more intelligent and environmentally friendly.
¶ 1.Nozzle
The S1 uses a short nozzle made of hardened steel, which is resistant to high temperatures, up to 350°, and wear-resistant. It is suitable for printing composite fliament such as carbon fiber, steel, wood, boron carbide, etc. in addition to conventional fliament.
¶ 2. Cooling device
Hot-end cooling: 2515 ordinary fans and heat sinks are used to dissipate heat from the hot-end throat to prevent premature melting of fliament caused by heat upload. 2515 ordinary fan is 5V, 15000 rpm.CPAP Turbo Fan: 37000 rpm, Minimum Cooling Time for Single Layer: 1 second. Function: Let the extruded material cool down quickly so that the model can be cooled and finalized in time, especially for models with overhanging structures.
¶ 3.Hot bed
It adopts silicone hot bed, 5mm aluminum plate, soft magnetic, PEI board, and uses Z-shaped fixings to fix the hot bed. It has better load-bearing, heat transfer and adhesion. The hot bed has two heating areas, which can be adjusted according to the model coordinate position. heating. Heating area: inner circle diameter 220mm, outer ring width 220-320mm.
¶ 4. Closed loop motor drive
The stepper motor of S1 adopts closed-loop control and has key technologies such as step number verification, step loss prevention, stall detection, and torque control. It has better stability, higher precision, high response, and high speed. In addition, it can Reduce motor heat.
¶ 5. Drying box
There are two ways to dry fliament, one is to use desiccant to dry the environment in the drying box, and the other is to heat and dry the drying box.
¶ 6. Lidar and binocular cameras
AI lidar and binocular cameras are used for first-layer detection, flow calibration and accuracy calibration.
¶ 7. Ordinary camera with X axis
Ordinary cameras can be used for real-time monitoring and time-lapse photography. When AI inspection is turned on, the camera can be combined to realize pasta detection and debris detection. When foreign objects or pasta are detected, printing will be paused and a warning will be issued.
¶ 8.Power supply
S1 uses a wide power supply, which can adapt to the voltage range of 110V-230V without manual adjustment settings