¶ Phenomenon:
¶ solution:
¶ 1. After slicing, check whether there are layer textures in the preview image. If so, it may be caused by incorrect parameter settings. You can use our original configuration parameters to re-slice.
¶ 2. Check whether the three belts are deformed or stretched, and whether the three belts have the same tightness. If there are obvious differences, adjust the belt tightness.
¶ 3. Check whether the parallel arm is deglued at the carbon rod and sleeve. If it is deglued, replace it with a new parallel arm.
¶ 4. Turn the parallel arm to see if there is obvious resistance. If there is obvious resistance, please apply grease to the fish eye head and fully lubricate it before leveling and printing again.
